Tally Outputs [Command Tally] - IDK MSD-5401 User Manual

8.17.4 Tally outputs [COMMAND Tally]

You can set the state of Tally output connector for when MSD is turned on.
This setting is valid only to the Tally output connector set to "PRESET COMMAND" in "8.15.1 Assigning
functions".
･AUTO
･OFF [Default]
･ON
If you select "AUTO" and turn on the MSD, the previous state of Tally output connector will be applied. To fix
the state, select "OFF" or "ON".
Setting
AUTO
OFF (Default)
* Even if you set it to "AUTO" or "ON","OFF" is output for approximately two seconds after turning off the MSD,
and then "ON" will then be output.
1. To set Tally output using menu:
MSD-5404
↓ SET key
[FUNCTION SELECT]
POWER ON SETTING
↓ SET key
[POWER ON SETTING]
COMMAND TALLY
↓ SET key
[COMMAND TALLY]
OFF
↓ ESC key: Returns to the previous screen.
2. To set Tally output using commands:
None
[Table 8.37] Tally output state
Previous Tally output
ON
Top
▲▼keys: Select "POWER ON SETTING".
▲▼keys: Select "COMMAND Tally".
▲▼keys: Select the desired Tally output mode. (AUTO, OFF, ON)
Tally output that will be applied
OFF
ON
241
when turning ON
OFF
*
ON
OFF
*
ON