Parallel - IDK MSD-5401 User Manual

8.14 Parallel

The MSD can be controlled from external contact points. Since photocoupler input is used for parallel input
connectors, it is electrically insulated from the connected device. When each pin of parallel input connector is
pulled to GND, functions assigned to these pins will be performed.
You can assign the following functions to each pin by following the instruction of "8.14.1 Assigning
functions".
1. Switching input channels
2. Changing channel switching modes (independent from the front panel switching mode)
3. Sending control commands
4. Locking/releasing parallel inputs
5. Turning on/off display devices
6. Operating menu
7. Locking/releasing front panel
8. Loading cross point/ preset memory
9. Adjusting audio output level
If the contact input operation is unstable due to switch chattering, change the chattering reduction time longer
in "8.14.7 Chattering reduction".
25
50
Amphenol full pitch 50 pin (female)
(MSD-5404 rear)
Pin
1, 26
2 ～ 24
27 ～ 49
25, 50
[Figure 8.59] Pin locations of parallel
input connector
1
26
Function
N.C.(No connection)
Function assignalbe
GND
N.C. : No Connection
+5V
470
Ω
MSD-5404
[Figure 8.60] Example of contact control circuit
194
MSD-54 SERIES User's Guide
1st pin
2nd pin
3rd pin
4th pin
Phase A
5th pin
Phase B
Rotary
encoder
25th pin