Editing Control Commands [Command Edit] - IDK msd-804fd User Manual

7.12.1 Editing control commands [COMMAND EDIT]

You can register up to 32 control commands.
Item
Select "COM" or "CEC".
PORT
Set the waiting time of the control command. Use this
DELAY item for devices such as projectors that requires time
to cool down after powering off.
Set the following communication ports to "OFF" (not
sending communication commands) or "ON" (sending
communication commands). Those ports can be set
separately, and communication commands can be
sent to multiple communication ports at the same
time.
Communication
- RS1: RS-232C CH1
*1
port
- RS2: RS-232C CH2
- OUT1B RS to OUT4B RS:OUT1B to OUT4B
- LOOP BACK: Internal loop back
- LAN1 to LAN8: LAN connections 1 to 8
- OUT1B LAN to OUT4B LAN:OUT1B to OUT4B
Set the number of bytes to be sent starting with the
*1
COM SIZE
first byte.
Set the input mode of send command data. Select
"ASCII" if "DATA" of "COMMAND" consists of only 0A,
COMMAND
*1
0D, and 20 to 7D of ASCII codes; select "HEX" if
INPUT MODE
"DATA" of "COMMAND" includes other codes.
Send command Set the command from the first byte according to the
*1
number of bytes set in "COM SIZE" (up to 30 bytes).
data
RECV DISPLAY
Set whether received data is displayed or not.
*1
[Table 7.11] Setting items of control commands
Description
*6
*6
(RS-232C of OUT1B to OUT4B)
(LAN port of OUTB1 to OUTB4B)
6 7
* *
*8
7 8
* *
152
MSD-804FD User's Guide
Range
COM: Communication
command [Default]
CEC: HDMI CEC
0 ms. to 999 seconds and 999
ms.
[Default]: 0 ms.
OFF [Default]
ON
0 byte to 30 bytes
[Default]: 0 byte
ASCII [Default]
HEX
0A, 0D, 20 to 7D of ASCII
codes (If inputting with ASCII
codes), or 00 to FF of hex (If
inputting with hex)
[Default]: 20 (Space)
(All numbers above are hex)
OFF [Default]
ASCII
HEX