IDK MSD-5401 User Manual page 152

1. To set the LAN operation mode using menu:
MSD-5404
↓ SET key
[FUNCTION SELECT]
LAN
↓ SET key
[LAN]
FUNCTION
↓ SET key
[CONNECTION1]
FUNC:RECIEVER
↓◄►keys
[CONNECTION2]
FUNC:TRANSMITTER
↓◄►keys
[CONNECTION2]
IP:192.168. 1.198
↓◄►keys
[CONNECTION2]
PJLink:OFF
↓◄►keys
[CONNECTION2]
PORT: 1100
or
[CONNECT2 PASSWORD]
1:
↓ SET key: Applies settings.
[LAN FUNCTION]
NOW UPDATE...
↓
[LAN]
FUNCTION
*1
Settable only if you select "TRANSMITTER".
*2
If setting PJLink protocol to "OFF", set the port number of the destination. If turning it "ON", set the
password.
*3
The number of characters at the cursor position is displayed at the lower left, and the maximum number of
the characters is 16. Space would be the final character, and characters before the space will be registered
as the password.
Note:
If you do not press the "SET" key, the LAN operation mode is not changed. Make sure to press the "SET" key.
2. To set the LAN operation mode using commands:
@SLF: Set LAN operation mode
@GLF Get LAN operation mode
Top
▲▼keys: Select "LAN".
▲▼keys: Select "FUNCTION".
↑ ESC key: Cancels the setting and returns to the previous screen.
▲▼keys: Select the desired mode of CONNECTION 1.
(RECIEVER, TRANSMITTER)
▲▼keys: Select the desired mode of CONNECTION 2.
(RECIEVER, TRANSMITTER)
▲▼keys: Set the IP address of CONNECTION 2 (0 to 255).
◄►keys: Moves the cursor.
▲▼keys: Select "OFF" or "ON" for PJLink protocol.
▲▼keys: Set the destination port no. of CONNECTION 2 (1 to 65535)
*2.
▲▼keys: Set the password of CONNECTION 2 (30 to 39, 41 to 5A, 61
to 7A from "9 ASCII codes").
◄►keys: Moves the cursor to the next character (Up to 32 characters).
The message is displayed for one second and then previous screen is
displayed automatically.
*1 *2 *3
152
MSD-54 SERIES User's Guide
*1
*1
*1