Analog Input Automatic Measurement [Auto Setup] - IDK MSD-5401 User Manual

8.6.6 Analog input automatic measurement [AUTO SETUP]

Analog RGB/ analog YPbPr video inputs are measured, and the following menus are set automatically: "8.6.1
The total number of horizontal dots", "8.6.2 Horizontal start position", "8.6.3 Horizontal display period",
"8.6.4 Vertical start position", "8.6.5 Vertical display period", and "8.6.11 Tracking".
Note:
In order to enable this menu, the input video must have 25% or more brightness and its edges (all sides) need
to be in contact with the circumscribed rectangle in the effective display area.
Input image
Measurable: contacting
circumscribed rectangle
If you input very black or extremely dark video, the measurement fails and a
message, "MEASUREMENT ERROR", is displayed.
1. To set the automatic measurement using menu:
MSD-5404
↓ SET key
[FUNCTION SELECT]
INPUT TIMING
↓ SET key
[INPUT TIMING]
AUTO SETUP
↓ SET key
[IN6 AUTO SETUP]
PUSH SET:NORMAL MODE
↓ SET key: Executes measurement
[IN6 AUTO SETUP]
NORMAL END
↓
[IN6 AUTO SETUP]
PUSH SET:NORMAL MODE
↓ ESC key: Returns to the previous screen.
*1
Normally, select "NORMAL MODE" (Automatic measurement of start position and display period). If edges
of video are not displayed correctly, use this mode to set the start position and display period automatically.
Input image
Valid display Valid display
area area
Measurable: contacting
circumscribed rectangle
[Figure 8.36] Example of input video
Top
▲▼keys: Select "INPUT TIMING".
▲▼keys: Select "AUTO SETUP".
↑ ESC key: Cancels measurement and returns to the previous screen.
▲▼keys: Select the desired measuring mode.
◄►keys: Select the desired input (IN1 to IN9).
SET keys: Executes the measurement and sets the input timing.
Displays the measurement result for 1 second and then returns to the
previous screen automatically.
MSD-54 SERIES User's Guide
Input image
Valid display
area
Immeasurable: not contacting
circumscribed rectangle
96
For each input port/input signal
MEASUREMENT ERROR
*1