Output Settings; Output Equalizer; Output Mode - IDK MSD-501 User Manual

MSD-501/502/701/702 User's Guide

7.8 Output settings

7.8.1 Output equalizer

Menu Top→OUTPUT SETTING→OUTPUT EQUALIZER
Setting for Each output (only OUTA)
Setting value OFF [Default],LOW,MIDDLE,HIGH
HDMI input connector has an equalizer circuit to correct attenuated signal caused when a long cable is
connected. Set the output equalizer according to the cable length.
Cable length
Equalizer setting

7.8.2 Output mode

Menu Top→OUTPUT SETTING→OUTPUT MODE
Setting for Each output (each OUTA / OUTB)
Setting value
・HDMI YCbCr4:4:4 MODE [Default]
・DVI MODE
You can select an output mode.
Set the mode to "HDMI YCbCr4:4:4 MODE" to output video with the optimal mode automatically even if a sink
device that does not support HDMI component signal or DVI signal is connected. If you want to output video
with HDMI RGB signal or DVI signal forcibly, set the desired mode.
The MSD checks signal types in order of the table below and output signal with the first matched signal type.
Output mode
DVI MODE
HDMI RGB MODE
HDMI YCbCr4:2:2 MODE
HDMI YCbCr4:4:4 MODE
50
[Table 7.6] Output equalizer
Shorter than10 m/32.8 ft.
OFF to MIDDLE
(IDK's cable, AWG 24, was used.)
[Table 7.7] Output mode priority
DVI
1st
2nd
3rd
4th
10 m/32.8 ft. or longer
LOW to HIGH
・HDMI RGB MODE
・HDMI YCbCr4:2:2 MODE
Signal supported by sink device
HDMI HDMI
RGB YCbCr4:2:2
- -
1st -
2nd 1st
3th 2nd
HDMI
YCbCr4:4:4
-
-
-
1st