Table of Contents
Advertisement
7.7
Output Settings
7.7.1
Output equalizer [OUTPUT EQUALIZER]
HDMI input connector has an equalizer circuit to correct attenuated signals caused when a long cable is
connected. Set the output equalizer according to the cable length.
･No correction: OFF [Default]
･Modest correction: LOW
･Middle correction: MIDDLE
･Significant correction: HIGH
[Table 7.1] Output equalizer
Cable length Shorter than 32.8 ft./10 m 32.8 ft./10 m or longer
Setting
STP : Shielded Twist Pair cable(AWG24)
If you use other manufacturers' cable, use this table only as a reference.
If a display device that is in a significantly bad condition is connected, the video may be distorted.
[Table 7.2] Amount of corrections
Setting of output
equalizer
OFF
LOW
MIDDLE
HIGH
1. To set the output equalizer using menu:
MSD-804FD
↓ SET key
[FUNCTION SELECT]
OUTPUT SETTING
↓ SET key
[OUTPUT SETTING]
OUTPUT EQUALIZER
↓ SET key
[OUT1A EQUALIZER]
OFF
↓ ESC key: Returns to the previous screen.
2. To set the output equalizer using commands:
@SEQ: Set output equalizer
@GEQ: Get output equalizer
"OFF" to "MIDDLE"
Amount of
corrections
0.0 dB
1.5 dB
3.5 dB
6.0 dB
Top
keys: Select "OUTPUT SETTING".
keys: Select "OUTPUT EQUALIZER".
keys: Select the desired output equalizer mode (OFF, LOW,
MIDDLE, HIGH).
◄ ► keys: Select the desired output (OUT1A to OUT4A).
"LOW" to "HIGH"
95
MSD-804FD User's Guide
For each output (only OUTA)
Advertisement
Table of Contents
