Configuring And Activating Interfaces; Monitoring Network Interface Cards - Nokia IP560 - Hard Disk Drive Based Installation Manual

4
Installing and Replacing Network Interface Cards
11. Tighten the retaining screws that hold the chassis tray assembly.
12. Turn the power on.

Configuring and Activating Interfaces

The IP560 appliance automatically detects any new NIC when the appliance is restarted. Use
Nokia Network Voyager to configure and activate the logical and physical interfaces on the NIC.
For information about how to access Network Voyager and the related reference materials, see
"Using Nokia Network Voyager"

Monitoring Network Interface Cards

You can asses the general operating condition of the NICs in your appliance by looking at the
LED status indicators on the NICs. The status indicators for each NIC are explained in the NIC
reference chapter.
For the status indicator information for the built-in 10/100/1000 Ethernet ports, see
10/100/1000 Ethernet NIC"
For the status indicator information for the four-port 10/100 Ethernet NIC, see
100 Ethernet NIC"
For the status indicator information for the built-in Ethernet ports or the two-port copper Gigabit
Ethernet NIC, see
page 56.
For the status indicator information for the built-in Ethernet ports or the two-port fiber-optic
Gigabit Ethernet NIC, see
Use Network Voyager to access detailed port information. For information about accessing
Network Voyager, see
tcpdump command to examine the track on a specific port.
52
SLOT 1 SLOT 2
Chassis tray assembly retaining
screws
on page 42.
on page 21.
on page 54.
"Four-Port and Two-Port Copper Gigabit Ethernet NIC (10/100/1000)"
"Two-Port Fiber-Optic Gigabit Ethernet NICs"
"Using Nokia Network Voyager"
SLOT 3 SLOT 4
1
2
3
4
on page 60.
on page 42. You can also use the IPSO
IP560 Security Platform Installation Guide
IP560
00354
"Four-Port
"Four-Port 10/
on