Init Led; System Ace Sd Controller; System Ace Sd Controller Reset; System Ace Sd Configuration Address Dip Switches - Xilinx Kintex-7 FPGA KC724 User Manual

INIT LED

The dual-color INIT LED DS25 (callout 16,
status. During FPGA initialization the INIT LED illuminates RED. When FPGA
initialization has completed the LED illuminates GREEN.

System ACE SD Controller

The onboard System ACE SD controller U32 (callout 17,
multiple configuration files on a Secure Digital (SD) card. These configuration files can be
used to program the FPGA. The SD card connects to the SD card connector J8 located
directly below the System ACE SD controller on the back side of the board.

System ACE SD Controller Reset

Pressing the SASD RESET push button SW7 (callout 18,
SD controller. The reset pin is an active-Low input.

System ACE SD Configuration Address DIP Switches

DIP switch SW8 shown in
addresses in the SD memory card. A switch is in the ON position if set to the far right and
in the OFF position if set to the far left. The MODE bit (switch position 4) is not used and
can be set either ON or OFF. SW8 is shown in
X-Ref Target - Figure 1-11
The switch settings for selecting each address are shown in
Table 1-5: SW8 DIP Switch Configuration
KC724 GTX Transceiver Characterization Board
UG932 (v2.2) October 10, 2014
Figure 1-11
SW8
Figure 1-11: Configuration Address DIP Switch (SW8)
Configuration Bitstream
Address
0
1
2
3
4
5
6
7
www.xilinx.com
Figure 1-2) indicates the FPGA's initialization
Figure 1-2) allows storage of
Figure 1-2) resets the System ACE
selects one of the eight configuration bitstream
Figure 1-2 as callout 19.
ADR0
ADR1
ADR2
MODE (Not Used)
UG932_c1_11_062712
Table
ADR2 ADR1
ON ON
ON ON
ON OFF
ON OFF
OFF ON
OFF ON
OFF OFF
OFF OFF
Detailed Description
1-5.
ADR0
ON
OFF
ON
OFF
ON
OFF
ON
OFF
19
Send Feedback