Configuring Y.1731 Ais; Configuring Ais In A Cfm Domain Service - Cisco NCS 5500 Series Configuration Manual

Configuring Ethernet CFM

Configuring Y.1731 AIS

This section has the following step procedures:

Configuring AIS in a CFM Domain Service

Use the following procedure to configure Alarm Indication Signal (AIS) transmission for a CFM domain
service and configure AIS logging.
SUMMARY STEPS
1. configure
2. ethernet cfm
3. domain name level level
4. service name bridge group name bridge-domain name
5. service name xconnect group xconnect-group-name p2p xconnect-name
6. ais transmission [interval {1s|1m}][cos cos]
7. log ais
8. end or commit
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 ethernet cfm
Example:
RP/0/RP0/CPU0:router(config)# ethernet cfm
Step 3 domain name level level
Example:
RP/0/RP0/CPU0:router(config-cfm)# domain D1
level 1
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release
6.1.x
60
Purpose
Enters global configuration mode.
Enters Ethernet CFM global configuration mode.
Specifies the domain and domain level.
Configuring Ethernet OAM