Chapter 10 Configuring Addres Pool; C H A P T E R 11 Configuring Local Aaa Server, User Database—Domain To Vrf - Cisco 10000-2P2-2DC Software Configuration Manual

About This Guide
Chapter Title
Chapter 8 Configuring ATM Permanent Virtual
Circuit Autoprovisioning
Chapter 9 Configuring the Multihop Feature
Chapter 10 Configuring Address Pools
Chapter 11 Configuring Local AAA Server, User
Database—Domain to VRF
Chapter 12 Configuring Traffic Filtering
Chapter 13 Unicast Reverse Path Forwarding
Chapter 14 Configuring Automatic Protection
Switching
Chapter 15 Configuring IP Multicast
Chapter 16 Configuring RADIUS Features
Chapter 17 Configuring L2 Virtual Private Networks Describes L2VPN features of both LS and AToM types
Chapter 18 Configuring L2VPN Interworking
Chapter 19 Configuring Multilink Point-to-Point
Connections
Chapter 20 Configuring Gigabit EtherChannel
Features
Chapter 21 Configuring IP Version 6
Chapter 22 Configuring Template ACLs
OL-2226-23
Description
Describes how to configure the ATM PVC autoprovisioning
feature that enables DSL wholesale service providers to
dynamically provision ATM service for subscribers using a
local configuration. Also describes the VBR-nrt
Oversubscription feature.
Describes how to configure the multihop feature that enables
the Cisco 10000 series router to terminate sessions arriving in
L2TP tunnels from LACs and to forward the sessions through
new L2TP tunnels to the router's peer L2TP Network Server
(LNS). Also describes how to configure the preservation of the
IP type of service (ToS) field for tunneled IP packets.
Describes address assignment mechanisms, including the
on-demand address pool manager feature and the overlapping
addresses feature. Describes how to configure each of these
features.
Describes the Local AAA Server, User Database—Domain to
VRF feature, which extends the Cisco IOS AAA Authorization
to local AAA profiles on the router without using an AAA
Server.
Describes the IP Receive ACLs and Time-Based ACLs features
that provide filtering capability for traffic that is destined for
the router and protects the router from remote intrusions.
Describes the Unicast Reverse Path Forwarding feature that
verifies if the path of an incoming packet is consistent with the
local packet forwarding information. The validity of this path
determines whether uRPF passes or drops the packet.
Describes the Multirouter Automatic Protection Switching
(MR-APS) feature that enables SONET connections to switch
from one SONET circuit to another SONET circuit if a circuit
failure occurs.
Describes the IP Multicast feature.
Describes the RADIUS attribute screening, RADIUS transmit
retries, RADIUS Attribute 31: PPPoX Calling-Station-ID, and
RADIUS packet of disconnect features.
available on Cisco 10000 series router.
Describes L2 interworking features available on
Cisco 10000 series router.
Describes MLP and how to configure it on serial and ATM
connections on the Cisco 10000 series router.
Describes Gigabit EtherChannel features available on
Cisco 10000 series router.
Lists the IPv6 features that are supported on the
Cisco 10000 series router and notes limitations of that support.
Describes Template ACLs, in which one ACL represents many
similar ACLs.
Cisco 10000 Series Router Software Configuration Guide
Document Organization
xxxi