Configuring Backup Disable Delay - Cisco CRS Configuration Manual

Configuring a Bridge Domain
Configures the pseudowire segment for the cross-connect.
Step 6 backup neighbor ip-address pw-id number
Example:
RP/0/RP0/CPU0:router(config-l2vpn-xc-p2p)# backup neighbor 1.1.1.1 pw-id 2
RP/0/RP0/CPU0:router(config-l2vpn-xc-p2p-pw-backup)#
Configures the backup pseudowire for the cross-connect.
Step 7
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuring Backup Disable Delay

The Backup Disable Delay function specifies the time for which the primary pseudowire in active state waits
before it takes over for the backup pseudowire. Perform this task to configure a disable delay.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-class class-name
4. backup disable delay seconds
5. exit
6. xconnect group group name
7. p2p xconnect name
8. neighbor ip-address pw-id number
9. pw-class class-name
10. backup neighbor ip-address pw-id number
11. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
76
Implementing Multipoint Layer 2 Services