Adding A Vlan Group To A Wlan - Cisco WLC 5700 Series Interface Configuration Manual

Configuring Interface Groups

Adding a VLAN Group to a WLAN

SUMMARY STEPS
1. conf t
2. wlan wlanname 1 wlanname
3. client vlan vlangrp1
4. end
DETAILED STEPS
Command or Action
Step 1
conf t
Example:
Step 2
wlan wlanname 1 wlanname
Example:
Step 3
client vlan vlangrp1
Step 4
end
Example:
Configuring the Trunk Port
Before You Begin
You must configure the VLAN after configuring the controller port as a trunk port. We recommend that you
configure the trunk port first and then associate the VLANs to the trunk port.
SUMMARY STEPS
1. show wireless interface summary
2. show run int te1/0/1
3. interface TenGigabitEthernet1/0/1
4. switchport trunk allowed vlan 1-10
5. switchport mode trunk
6. nmsp attachment suppress
7. end
OL-32314-01
Purpose
Enters global configuration mode.
Enables the WLAN to map a VLAN group.
Maps the VLAN group to the WLAN.
Returns back to exec mode.
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
Adding a VLAN Group to a WLAN
65