Verifying Line Configuration; Configuring Inverse Multiplexing For Atm; Table 3-3 Dspln Command Parameters - Cisco MGX 8850 (PXM1E/PXM45) Configuration Manual

General PXM1E Configuration Procedures
Table 3-2
the parameters listed for E3 lines.
Step 5 To verify your configuration changes, enter the dspln command.

Verifying Line Configuration

To display the configuration of a line, use the following procedure.
Establish a CLI management session at any user access level.
Step 1
Step 2 If you do not know the line number you want to view, display a list of the lines by entering the following
command:
mgx8830b.2.PXM.a > dsplns
To display the configuration of a single line, enter the following command:
Step 3
mgx8830b.2.PXM.a > dspln -type <bay.line>
Table 3-3
mgx8830b.2.PXM.a > dspln -sonet 2.1
Line Number
Admin Status
Loopback
Frame Scrambling
Xmt Clock source
Line Type
Medium Type(SONET/SDH) : SONET
Medium Time Elapsed
Medium Valid Intervals : 73
Medium Line Type
Table 3-3
Parameter
type
bay
line

Configuring Inverse Multiplexing for ATM

The Inverse Multiplexing for ATM (IMA) feature enables multiple T1 or E1 lines to be grouped into a
single high-speed ATM port. The advantage of the IMA feature is that you do not need T3/E3 circuits to
support high bandwidth on your switch. On Cisco MGX 8850 (PXM1E) and Cisco MGX 8830 switches,
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
3-28
lists the parameter descriptions for configuring SONET, DS3 and E3 lines. Be sure to use only
describes the dspln command parameters. The line configuration appears as follows:
: 2.1
: Up
: NoLoop
: Enable
: localTiming
: sonetSts3c
: 80
: ShortSMF
dspln Command Parameters
Description
The parameter specifies the type of line that is connected to the switch. Replace
<type> with -ds1, -e1, -ds3, -e3, or -sonet. Use the dsplns command to view the
configured line type in the Line Type column.
Replace <bay> with 2 to indicate that the line is connected to a PXM1E back card in
the lower bay.
Replace <line> with the number that corresponds to the line for which you want to
display information.
Chapter 3 Provisioning PXM1E Communication Links
Alarm Status : Clear
APS enabled : Enable
Number of ports : 1
Number of partitions: 1
Number of SPVC : 0
Number of SPVP : 0
Number of SVC : 0
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004