Part Names - Mitsubishi Electric MELSEC iQ-F FX5 User Manual

Part names

This section describes the part names of the analog input module.
2-  4.5 mounting holes
[3]
[4]
[2]
[5]
[1]
[9]
No. Name
[1] Terminal block (Spring clamp terminal block)
[2] Expansion cable
[3] Direct mounting hole
[4] Operations status display LEDs
[5] Extension connector
[6] Name plate
[7] DIN rail mounting groove
[8] DIN rail mounting hook
[9] Pull out tab
LED display
The following table lists the LED display.
LED display LED color
POWER Green
RUN Green
ERROR Red
ALM Red
[6]
Description
Used for current/voltage input.
Cable for connecting the module when adding the analog input module.
Screw holes (2-4.5, mounting screw: M4 screw) for direct installation.
Indicates the operating status of the module. (Page 23 LED display)
Connector for connecting the extension cable of an extension module.
The product model name and manufacturer's serial number are shown.
The module can be installed on DIN46277 rail (35 mm wide).
Hook for mounting the module on a DIN rail of DIN46277 (35 mm wide).
They are used when drawing out an extension cable.
Description
Indicates the power supply status.
ON: Power ON
OFF: Power off or module failure
Indicates the operating status.
Light on: Normal operation
Flashing: Offset/gain setting mode
Light off: Error occuring
Indicates the error status.
ON: Minor error
Flashing: Moderate error or major error
OFF: Normal operation
Indicates the output status.
Light on: Process alarm or rate alarm issued
Flashing: Input signal error
Light off: Normal operation
[7]
[8]
1
1 FX5-4AD
23
1.2 Specifications