Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 255

5.
Drag the created end point to adjust its position.
Drag
The end point position can be adjusted also by changing the "End point" and "Digital value" values in "Wave detail setting".
Item Description
Start point The end point of the previous section is displayed. To change it, change the end point of the previous section.
End point Set the number of pieces of data of the target terminal point. Since section No.1 represents the first point of the wave pattern, it
cannot be changed.
Digital value Set the digital value of the target terminal point.
6.
Repeat steps 3 to 5 to create the wave to be output.
Each digital value of the created wave pattern can be shown using the [Display Digital Value] button. To clear the contents of
the created wave pattern, click the [Initialize Graph] button. The graph and the contents of "Wave detail setting" are cleared.
7.
To save the wave pattern, click [Save Wave Pattern] or [Write CSV File].
Page 254 Save the wave pattern
8.
Click the [OK] button on the "Register wave pattern" window.
9.
Repeat steps 1 to 8 to create another wave pattern.
2 FX5-4DA
253
2.7 Parameter Settings
2