Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 169

■Default value
The default values are set as shown below.
Channel
CH1
CH2
CH3
CH4
When the FX3 allocation mode function is used, the following applies.
Channel
CH1
CH2
CH3
CH4
CH1 Trigger setting value
Set a level to generate a level trigger.
For details on the logging function, refer to the following.
Page 59 Logging function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Trigger setting value
CH Trigger setting value (In FX3 allocation
mode function)
■Setting range
The possible setting range is from -32768 to +32767.
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is 0 for all channels.
Default value
402
602
802
1002
Default value
10
11
12
13
CH1 CH2
542 742
9231 9232
Buffer memory area to be monitored
CH1 Digital operation value (Un\G402)
CH2 Digital operation value (Un\G602)
CH3 Digital operation value (Un\G802)
CH4 Digital operation value (Un\G1002)
Buffer memory area to be monitored
CH1 Digital operation value (Un\G10)
CH2 Digital operation value (Un\G11)
CH3 Digital operation value (Un\G12)
CH4 Digital operation value (Un\G13)
CH3 CH4
942 1142
9233 9234
Appendix 4 Buffer Memory Areas
A
APPX
167