Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 451

Level data 0 to 9
This area stores data to be monitored when a level trigger of the logging function is used. Ten types of data are available:
'Level data 0' (Un\G90) to 'Level data 9' (Un\G99). These are useful, for example, to generate triggers while monitoring the
values of devices other than the multiple input module.
For details on the logging function, refer to the following.
Page 371 Logging function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Level data
Level data (in FX2N allocation mode
function)
■Setting range
The possible setting range is from -32768 to +32767.
■Default value
The default value is 0 for all the channels.
Mode switching setting
Set a setting value for the mode to be switched.
Switching mode
Buffer memory address
Normal mode
Offset/gain setting mode
When a value out of the above is written and 'Operating condition setting request' (Un\G70, b9) is turned
offonoff, the mode setting is not performed and only the operating condition is changed. In this case, this
area is cleared to 0.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Mode switching setting
Mode switching setting (in FX2N allocation mode function)
■Enabling the setting
Turn offon 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■After the mode is switched
When the mode is switched, this area is cleared to 0 and 'Operating condition setting completed flag' (Un\G69, b9) turns off.
After checking that 'Operating condition setting completed flag' (Un\G69, b9) is off, turn off 'Operating condition setting
request' ((Un\G70, b9).
0 1 2 3
90 91 92 93
9010 9011 9012 9013
Setting value
296
4658H
4144H
CH1 CH2
296, 297
126, 127
4 5 6 7
94 95 96 97
9014 9015 9016 9017
297
4144H
4658H
CH3 CH4 CH5 CH6
Appendix 12 Buffer Memory Areas
8 9
98 99
9018 9019
A
CH7 CH8
APPX
449