Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 307

Disconnection detection automatic clear enable/disable setting
Set whether to enable or disable an automatic clear of disconnection detection of the disconnection detection function.
The setting is enable only in the normal output mode.
Setting value
0
1
Setting a value other than in the table above results in operation with Disable (1).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
Disconnection detection automatic clear enable/
disable setting
Disconnection detection auto-clear enable/
disable setting (in FX3 allocation mode function)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
• In the normal mode: The default value is Disable (1) for all the channels.
• In the FX3 allocation mode: The default value is Enable (0) for all the channels.
Offset/gain initialization enable code
When the 'offset/gain initialization request' (Un/G70, b5) turns on from off by setting the enable code "E20FH" in this area at
the time of initialization of offset/gain, the offset value and the gain value in the flash memory of the analog output module are
initialized.
When setting anything other than "E20FH" in this area, initialization is not executed.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
Offset/gain initialization enable code
Offset/gain initialization enable code (In FX3
allocation mode function)
■Default value
The default value is 0.
Description
Enable
Disable
CH1 CH2
304
3170
CH1 CH2
305
4160
CH3 CH4
CH3 CH4
Appendix 8 Buffer Memory Areas
A
APPX
305