Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 478

CH1 Logging data setting
Determine the target to be collected: digital output value or digital operation value.
For details on the logging function, refer to the following.
Page 371 Logging function
Setting value
0
1
Setting a value other than the above causes a logging data setting range error (error code: 1D3H).
When 'CH1 Logging enable/disable setting' (Un\G535) is set to Disable (1), the setting for 'CH1 Logging data setting'
(Un\G536) is ignored.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Logging data setting
CH Logging data setting (in FX2N allocation mode function)
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is Digital operation value (1).
CH1 Logging cycle setting value
Set a cycle for storing the logging data.
For details on the logging function, refer to the following.
Page 371 Logging function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Logging cycle setting value
CH Logging cycle setting value (In FX2N allocation mode
function)
■Setting range
The setting range varies depending on the setting in 'CH1 Logging cycle unit setting' (Un\G538) and 'CH1 Input type/range
setting' (Un\G598).
CH1 Logging cycle unit setting (Un\G538)
ms (1)
s (2)
• Setting a value out of the above range causes a logging cycle setting value range error (error code: 1D1H). Logging
cannot be performed.
• If the set logging cycle is below the update cycle of data to be logged, a logging cycle setting disable error (error code:
1D2H) occurs. Logging cannot be performed.
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is set to 1.
APPX
476
Appendix 12 Buffer Memory Areas
Setting content
Digital output value
Digital operation value
CH1 CH2
536 736
9171 9172
CH1 CH2
537 737
9181 9182
CH1 Input type/range setting (Un\G598)
Current/Voltage
Resistance temperature detector/thermocouple
CH3 CH4 CH5
936 1136 1336
9173 9174 9175
CH3 CH4 CH5
937 1137 1337
9183 9184 9185
Setting range
1 to 32767
40 to 32767
1 to 3600
CH6 CH7 CH8
1536 1736 1936
9176 9177 9178
CH6 CH7 CH8
1537 1737 1937
9186 9187 9188