Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 138

Interrupt factor reset request [n]
An interrupt factor reset request is sent.
Setting value
0
1
When Reset request (1) is set to 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) corresponding to the interrupt factor,
the interrupt factor corresponding to the specified interrupt is reset. After that, 'Interrupt factor detection flag [n]' (Un\G4 to
Un\G19) turns to 'No interrupt factor' (0). When the set value is two or larger, the setting is regarded as Reset request (1).
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor reset request
[n]
Interrupt factor reset request
[n] (in FX3 allocation mode
function)
■Default value
The default value is 0 for all channels.
Interrupt factor transaction setting [n]
Set an interrupt request for when the same interrupt factor occurs during the interrupt factor detection.
Setting value
0
1
• With 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) set to Interrupt resend request (0) and an interrupt factor
being detected, an occurrence of the same interrupt factor results in an interrupt request being sent to the CPU module
again.
• With 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) set to No interrupt resend request (1) and an interrupt
factor being detected, an occurrence of the same interrupt factor does not result in an interrupt request being sent to the
CPU module.
If a value other than the above is set, an interrupt factor generation setting error (error code: 180H) occurs.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor transaction
setting [n]
Interrupt factor transaction
setting [n] (in FX3 allocation
mode function)
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is 0 for all channels.
APPX
136
Appendix 4 Buffer Memory Areas
1 2 3 4 5
156 157 158 159 160
4064 4065 4066 4067 4068
1 2 3 4 5
200 201 202 203 204
4061 4062 4063 4064 4065
Setting content
No reset request
Reset request
6 7 8 9 10
161 162 163 164 165
4069 4070 4071 4072 4073
Setting content
Interrupt resend request
No interrupt resend request
6 7 8 9 10
205 206 207 208 209
4066 4067 4068 4069 4070
11 12 13 14 15
166 167 168 169 170
4074 4075 4076 4077 4078
11 12 13 14 15
210 211 212 213 214
4071 4072 4073 4074 4075
16
171
4079
16
215
4076