Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 468

CH1 Scaling lower limit value
Set a lower limit value for the range of the scale conversion.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Scaling lower limit value
CH Scaling lower limit value (In FX2N allocation mode
function)
■Setting range
The possible setting range is from -32000 to +32000.
Setting a value out of the range causes a scaling setting range error (error code: 1A1H).
In the channel where a set value does not satisfy the condition "the scaling upper limit value  the scaling lower limit value", a
scaling upper/lower limit value setting error (error code: 1A2H) occurs.
When 'CH1 Scaling enable/disable setting' (Un\G504) is set to Disable (1), the setting for 'CH1 Scaling lower limit value'
(Un\G508) is ignored.
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is set to 0.
CH1 Digital clipping enable/disable setting
Set whether to enable or disable the digital clipping function.
For details on the digital clipping function, refer to the following.
Page 351 Digital clipping function
Setting value
0
1
If a value other than the above is set, a digital clipping enable/disable setting range error (error code: 1A5H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Digital clipping enable/disable setting
CH Digital clipping enable/disable setting (In FX2N allocation
mode function)
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is Disable (1).
APPX
466
Appendix 12 Buffer Memory Areas
CH1 CH2 CH3
508 708 908
1121 1123 1125
Setting content
Enable
Disable
CH1 CH2 CH3
510 710 910
1141 1142 1143
CH4 CH5 CH6
1108 1308 1508
1127 1129 1131
CH4 CH5 CH6
1110 1310 1510
1144 1145 1146
CH7 CH8
1708 1908
1133 1135
CH7 CH8
1710 1910
1147 1148