Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 298

Turn on and off 'Error clear request' (Un\G70, b15) , and set CH Wave output start/stop request to Wave output start request
(1).
If disconnection detection auto-clear enable/disable setting is enable, perform the following. Analog output restarts according
to the state of CH Output enable/disable flag (Un\G70, b1-4).
• In the normal output mode
When the cause of the disconnection is eliminated from the disconnected state, analog output restarts.
At the same time analog output restarts, the disconnection detection flag of the corresponding channel is
cleared.
Operation mode monitor
The current normal mode can be checked.
Monitor value
0H
1H
2H
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Operation mode monitor
Operation mode monitor (In FX3 allocation mode
function)
Input signals
A state of an analog output module can be checked in the buffer memory area.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Input signals
Input signals (In FX3 allocation mode function)
■List of input signals
Buffer memory
b0
b1 to 4
b5
b6
b7
b8
b9
b10
b11
b12
b13
b14
b15
APPX
296
Appendix 8 Buffer Memory Areas
Description
Normal output mode
Offset/gain setting mode
Wave output mode
CH1 CH2
60
3160
CH1 CH2
69
69
Description
Module READY
Use not allowed
Offset/gain initialization completed flag
Use not allowed
External power supply READY flag
Use not allowed
Operating condition setting completed flag
Offset/gain setting mode status flag
Channel change completed flag
Set value change completed flag
Disconnection detection signal
Alert output signal
Error flag
CH3 CH4
CH3 CH4