Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 126

Interrupt factor detection flag [n]
The detection status of the interrupt factor is stored.
Monitor value
0
1
When an interrupt factor occurs, an interrupt request is sent to the CPU module at the same time as 'Interrupt factor detection
flag [n]' (Un\G4 to Un\G19) turns to Interrupt factor (1).
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor detection flag
[n]
Interrupt factor detection flag
[n] (in FX3 allocation mode
function)
Module information
Module information of FX5-4AD is stored. For module information, 6140H (fixed hexadecimal value) is stored.
• In the normal mode: 6140H
• In the FX3 allocation mode: 6144H
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Module Information
Module information (in FX3 allocation mode
function)
Firmware version
Firmware version is stored. Firmware version is stored in 4 digit decimal number.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Firmware version
Firmware version (in FX3 allocation mode
function)
APPX
124
Appendix 4 Buffer Memory Areas
1 2 3 4 5
4 5 6 7 8
4001 4002 4003 4004 4005
CH1
30
30
CH1
31
3131
Description
No interrupt factor
Interrupt factor
6 7 8 9 10
9 10 11 12 13
4006 4007 4008 4009 4010
CH2
CH2
11 12 13 14
14 15 16 17
4011 4012 4013 4014
CH3 CH4
CH3 CH4
15 16
18 19
4015 4016