Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 321

CH1 Output value during wave output stop
This area is for setting the value to be output when Output value during wave output stop (2) is set in 'CH1 Output setting
during wave output stop' (Un\G524).
The setting for this area is enabled only in the wave output mode. In other modes, changing the setting value is ignored.
The setting range depends on the set output range. Configure the setting in the following range.
Output range
6: 0 to 5V
5: 1 to 5V
2: 0 to 20mA
3: 4 to 20mA
7: 0 to 10 V
0: -10 to +10V
In the channel where a value out of the setting range is set, an output value during wave output stop setting range error (error
code: 1D3H) occurs and 'Error flag' (Un\G69, b15) turns on. The wave output does not start.
However, when a value other than Output value during wave output stop (2) is set in 'CH1 Output setting during wave output
stop' (Un\G524), the above error does not occur.
Since the default value is 0, change the setting value if 'CH1 Output setting during wave output stop' (Un\G524) is set to
Output value during wave output stop (2).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Output value during wave output stop
CH Output value during wave output stop (in
FX3 allocation mode function)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is 0 for all channels.
CH1 Wave pattern start address setting
This area is for setting the start address of the wave pattern to be output when the wave output function is used.
The setting for this area is enabled only in the wave output mode. In other modes, changing the setting value is ignored.
In the channel where the set values in this area and in 'CH1 Wave pattern data points setting' (Un\G528, Un\G529) satisfy the
following conditions, a wave data registry area range error (error code: 1D9H) occurs and 'Error flag' (Un\G69, b15) turns
on. The wave output does not start.
(Wave pattern start address setting + Wave pattern data points setting - 1) > 89999 (the last buffer memory address of the
wave data registry area)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Wave pattern start address setting
CH Wave pattern start address setting (in FX3
allocation mode function)
■Setting range
The possible setting range is from 10000 to 89999. (10000 to 89999 of buffer memory)
In the channel where a value out of the setting range is set, a wave pattern start address setting range error (error code:
1D4H) occurs and 'Error flag' (Un\G69, b15) turns on. The wave output does not start.
Setting range
0 to 32767 (practical range: 0 to 32000)
-32768 to +32767 (practical range: -32000 to +32000)
CH1 CH2
525 725
9171 9172
CH1 CH2
526, 527 726, 727
9180, 9181 9182, 9183
CH3 CH4
925 1125
9173 9174
CH3 CH4
926, 927 1126, 1127
9184, 9185 9186, 9187
Appendix 8 Buffer Memory Areas
A
APPX
319