CH1 Difference conversion trigger
Use this buffer memory area as a trigger to start or stop the difference conversion.
For details on the difference conversion function, refer to the following.
Page 41 Difference operation function
Setting value
0
1
Setting a value other than the values in the table above results in operation with Trigger request (1).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Difference conversion trigger
CH Difference conversion trigger (in FX3
allocation mode function)
■Starting and stopping the difference conversion
• When the setting value is turned from No request (0) to Trigger request (1), the difference conversion starts.
• When the setting value is turned from Trigger request (1) to No request (0), the difference conversion stops.
■Default value
The default value is No request (0) for all channels.
CH1 Logging hold request
Use this buffer memory area as a trigger to hold (stop) logging at any timing during the logging.
For details on the logging function, refer to the following.
Page 59 Logging function
Logging hold request
OFF
ON
Setting a value other than in the table above results in operation with ON (1).
When 'CH1 Logging enable/disable setting' (Un\G535) is set to Disable (1), the setting for 'CH1 Logging hold request'
(Un\G471) is ignored.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Logging hold request
CH Logging hold request (In FX3 allocation
mode function)
■Operation of the logging hold processing
• When Disable (0) is set to 'CH1 Level trigger condition setting' (Un\G540), the logging hold processing starts by turning
offon 'CH1 Logging hold request' (Un\G471).
• When a value other than Disable (0) is set to 'CH1 Level trigger condition setting' (Un\G540), the logging hold processing
starts after 'CH1 Logging hold request' (Un\G471) is turned offon and the set trigger condition is satisfied. When the level
trigger is enabled, use this buffer memory area as an interlock condition to operate the level trigger.
• If 'CH1 Logging hold request' (Un\G471) is turned onoff during the logging hold processing, the hold (stop) status is
cleared and the logging restarts.
APPX
150
Appendix 4 Buffer Memory Areas
Setting content
No request
Trigger request
CH1
CH2
470
670
1381
1382
Setting value
0
1
CH1
CH2
471
671
9151
9152
CH3
CH4
870
1070
1383
1384
CH3
CH4
871
1071
9153
9154