Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 220

Points on using the wave output function
■If 'CH1 Output enable/disable flag' (Un\G70, b1) was changed during wave output
When 'CH1 Output enable/disable flag' (Un\G70, b1) is turned onoff during wave output, the wave output does not stop
although the analog output value changes to the offset value. The wave output update continues also while 'CH1 Output
enable/disable flag' (Un\G70, b1) is off. Turning offon 'CH1 Output enable/disable flag' (Un\G70, b1) restarts the analog
output.
CPU module status
CH1 D/A conversion
enable/disable setting (Un\G500)
CH1 Output enable/disable flag
(Un\G70, b1)
CH1 Wave output start/stop
request (Un\G462)
CH1 Wave output status monitor
(Un\G401)
Wave data
Output value as per the setting of CH1
Output setting during wave output stop (Un\G524)
2 FX5-4DA
218
2.4 Functions
D/A conversion enable (0)
OFF ON
Wave output stop request (0)
Wave output stopped (0)
Analog output
Offset value
RUN
OFF ON
Wave output start request (1)
Wave output Wave output
in progress (1) stopped (0)