Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 314

CH1 Input value shift amount
The set value is added to the digital input value regardless of the on/off status of 'Operating condition setting request'
(Un\G70, b9).
For the shift function, refer to the following.
Page 191 Shift function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Input value shift amount
CH Input value shift amount (in FX3 allocation
mode function)
■Setting range
The setting range is from -32768 to +32767.
■Default value
The default value is 0 for all channels.
CH1 Wave output step action movement amount
This area is for setting the wave output step action movement amount and for checking if the target has been obtained.
The value set in this area is subtracted from or added to the buffer memory address that has been storing the value and so the
buffer memory address of Wave data registry area that has been storing the target digital value is specified. When a value is
set in this area, the target address starts to be specified and when specifying the address is complete, No movement (0) is
stored.
The setting for this area is enabled only when the following conditions are satisfied.
• In the wave output mode
• When During wave output step action (3) is stored in 'CH1 Wave output status monitor' (Un\G401).
Movement direction
No movement
Forward movement (movement in the direction to increase the address)
Reverse movement (movement in the direction to decrease the address)
The setting range is from -30000 to +30000. Even if a set value is out of the setting range, no error occurs. When a value
smaller than -30000 is set, the value is processed as -30000. When a value greater than 30000 is set, the value is processed
as 30000.
The following shows the available range for movement.
• "Wave pattern start address" to "Wave pattern start address" + "Wave pattern data points setting" - 1
If a value equal to or more than the wave pattern data points is set, only the data for the wave pattern data points is
processed.
Set a value for the wave output step action movement amount. When specifying the address is complete, No movement (0) is
stored in this area.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Wave output step action movement
amount
CH Wave output step action movement
amount (in FX3 allocation mode function)
■Default value
The default value is No movement (0) for all channels.
APPX
312
Appendix 8 Buffer Memory Areas
CH1 CH2
480 680
3250 3252
Setting value
0
1 to 30000
-30000 to -1
CH1 CH2
482 682
9140 9142
CH3 CH4
880 1080
3254 3256
CH3 CH4
882 1082
9144 9146