Connection and disconnection of the cable
■Connection of the cable
Fully insert a cable whose end has been properly processed into the wire insertion opening.
If the cable cannot be inserted with this procedure, fully insert the cable while pushing the open/close button with a flathead
screwdriver having a tip width of 2.0 to 2.5 mm. After fully inserting the cable, remove the screwdriver.
Wire insertion opening
PHOENIXCONTACT GmbH & Co. KG
Pull the cable or bar solderless terminal slightly to check that the cable is securely clamped.
■Disconnection of the cable
While pushing the open/close button with a flathead screwdriver having a tip width of 2.0 to 2.5 mm, disconnect the cable.
SZS 0.4 2.5 VDE