Installing Blank Cards Into The Input Card Hopper - HID Fargo DTC1250 User Manual

DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0

Installing Blank Cards into the Input Card Hopper

The FARGO DTC1250e, DTC1000Me and DTC4250e Card Printers are capable of printing single feed
cards and multiple feed cards (batch mode). To print a single feed card, remove all cards from the input card
hopper, leave its door closed and place a card in the single feed card slot (which can be used repeatedly).
Procedure
Step
1 Load the cards with the print side down and (if applicable) the magnetic strip up and
towards the front of the printer.
through the Printer.
•
•
•
•
•
•
2 Open the input card hopper door.
Page 18
Caution: Do not run the cards with a contaminated, dull or uneven surface
Printing onto such cards may lead to poor print quality and can greatly reduce the life
of the printhead.
Card types include PVC or PVC finish.
Cards eject into the output hopper or reject hopper.
Each input hopper holds 100 cards.
Certain types of smart card chips are raised slightly above the cards surface, which
may result in poor color transfer. Design the card with white space surrounding the
chip.
To print using single feed, remove all cards from the input card hopper, leave its door
closed. Place a card in the single feed card slot (which can be used repeatedly).
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
October 2013