Attaching/Removing The Battery Pack - NTT docomo FOMA D703i User Manual

Attaching/removing the battery pack

･
Turn the power off before attaching or removing the battery pack.
･
Be careful not to touch the camera lens.
･
Use the specified Battery Pack D08.
Attaching the battery pack
Removing the battery pack
INFORMATION
The FOMA terminal display uses an active LCD. Due to the characteristics of active LCD, residual images or crossbar
●
may remain for a while when the battery pack is attached or removed. This is not a fault of FOMA terminal.
aRemove the back cover.
Press here.
bWith the surface with the DoCoMo logo and
cPush the battery pack in.
dPlace the back cover plate so that it can slide
eSlide the back cover in the direction of the
Failure to follow the correct procedure could
damage the back cover.
Projection part
While pressing the top of the back cover with
your thumb, slide it in the direction of the arrow
until it is removed.
the recycle mark facing up, insert the battery
pack into FOMA terminal at the angle as
shown in the figure.
Do not force the battery pack into FOMA
terminal. Doing so could damage the body
connector or battery pack terminals.
about 3 mm on FOMA terminal.
arrow pushing its center with your thumb so
that FOMA terminal and the back cover do
not gap.
aRemove the back cover.
bLift the projection part of the battery pack
and remove it.
Before Using D703i 35