NTT docomo FOMA D703i User Manual page 419

Optimizing packet communication setup
Optimize the PC packet communication setup for
FOMA network by means of W-TCP setup.
The W-TCP setup is a TCP parameter tuning tool for
optimizing TCP/IP transmission capacity during packet
communication in the FOMA network. To enable
communication capability of FOMA terminal to
maximum extent, this communication setup is
required.
For Windows XP
System optimization can be performed for each
dialup connection.
Start FOMA PC
1 設定ソフト
Click W-TCP
設定
■
Starting from the task tray: Click
2
Perform the following operations:
■
When the system has not been optimized:
The following screen is displayed.
a Select 384Kbps and click
b Select the dialup connection to be
z
optimized
Optimization of the system settings and
dialup settings are performed respectively.
■ When the system has been optimized:
The following screen is displayed. Change the
check box and click
setting) if changes are to be made.
z
(☛P8)
最適化を行う
実行
Click (Execute)
システム設定
(System
3 Reboot the PC following the instruction
shown on the screen
･
The settings take effect after rebooting the PC.
For Windows 2000
Start FOMA PC
1
Click W-TCP
■ Starting from the task tray: Click
最適化を行う
2 Click
3 Reboot the PC following the instruction
shown on the screen
･
The settings take effect after rebooting the PC.
Canceling optimization
･
Cancel optimization in case of executing 64K data
communication or when communicating via other
than FOMA terminal.
For Windows XP
Start FOMA PC
1
Click W-TCP
■ Starting from the task tray: Click
2
Remove the check of the dialup connection
to cancel optimization
設定
(System setting)
･
When the system is optimized for 3.6Mbps, the
dialup connection cannot be selected
individually. Click
setting).
14
設定ソフト
(☛P8)
設定
設定ソフト
(☛P8)
設定
z
Click システム
システム設定
(System
z
z
Next