NTT docomo FOMA D703i User Manual page 408

Glossary of data communication
● Administrator privilege
A user level that provides complete access to all OS
functions in Windows XP and 2000. There must be
at least one user that has administrator privileges for
each PC. A user that has no administrator privileges
is not normally allowed to install/uninstall drivers and
software.
● APN (Access Point Name)
String to identify a provider, etc. to connect by
packet communication. The APN for mopera U is
"mopera.net" and mopera is "mopera.ne.jp".
● cid (Context Identifier)
The registration number when writing packet
communication dialup connection (APN) information
to FOMA terminal. 10 numbers from 1 to 10 are
available for FOMA terminal.
By default, "mopera.ne.jp" is registered in cid1, and
"mopera.net" in cid3.
● W-TCP
A TCP parameter designed to fully utilize TCP/IP
transmission capacity during packet
communications in a FOMA network. This
communication setting is essential to enable full use
of FOMA terminal capability.
Flow of setup for data communication
The setup work needed to connect FOMA
terminal to a PC to perform packet or 64K data
communication is as follows:
a Install the communication configuration file ☛P5
b Connect FOMA terminal to a PC ☛P4
c Check the communication configuration file
☛P5
Install the FOMA PC configuration software ☛P6
(Easy Setup)
Packet communication
setup
● mopera U / mopera
☛P8
● Other providers ☛P9
Execute communication ☛P12 (Disconnect ☛P13)
Set up communications without using the FOMA PC
configuration software ☛P17
Connect ☛P23 (Disconnect ☛P24)
(Easy Setup)
64K data communication
setup
● mopera U / mopera
☛P11
● Other providers ☛P12
Communication configuration file (driver)
Install the communication configuration file on a PC
from the attached CD-ROM before connecting FOMA
terminal to a PC to perform data communication.
FOMA PC configuration software
When the FOMA PC configuration software (found on
the attached CD-ROM) is installed on a PC, a
number of settings required for packet
communication or 64K data communication via
connection between FOMA terminal and PC can be
made from the PC by simple operation.
Before installation/uninstallation
･
Installing/uninstalling the communication
configuration file or the FOMA PC configuration
software can only be performed by a user with
administrator privileges. Attempts made by other
users will result in errors. For details on PC
administrator privileges, refer to the instruction
manual of the PC or contact your PC manufacturer
or Microsoft Corporation.
･
Before starting operation, make sure that no other
program is running. If there is any active program,
save and exit the program before operation.
3