NTT docomo FOMA D703i User Manual page 325

Item Operation procedure
Arrival call act Call Forwarding:
Incoming voice/videophone calls or
Default
Answer 64K data communication received
during a call or 64K data
communication are forwarded.
• The 64K data communication
received during a 64K data
communication cannot be forwarded.
Call Rejection:
Incoming voice/videophone calls or
64K data communication received
during a call or 64K data
communication are rejected.
Activate the response method selected by
Set arrival act;
Activate Arrival call act.
81 z
82 z
Set arrival act;
Deactivate
83 z
Set arrival act;
Check setting
INFORMATION
Even if Arrival call act is set to any of the above, calls will
●
be recorded in the received call history.
Setting Remote Control
This service allows you to control Voice Mail
Service or Call Forwarding Service from touch-
tone general subscriber phones, payphones or
DoCoMo mobile phones.
m8762
1
2 Perform the following operations
Item Operation procedure
1 z
Activate
Select Yes
2 z
Deactivate Select Yes
3 z
Check setting
Select Yes
Using Multi Number
Up to 2 additional numbers (Additional No1 and
Additional No2) can be used besides Basic Number
for the phone number of your FOMA terminal.
Select Yes
Select Yes
Select Yes
Remote Control
Multi Number
･
If you pull out the UIM or replace it by another
UIM, the settings for Multi Number saved in
FOMA terminal (name, phone number etc.) may
be deleted. In this case, however, you can
register them again.
･
The names corresponding to the multi-numbers
(Basic Number/Additional No1/Additional No2) are
displayed on the screen while you are dialing/
receiving calls.
･
When you make a call from the redial data or
received call history, the multi-numbers which
have been used for the previous incoming/
outgoing calls are displayed and you make the
call from the numbers.
m8767
1
2 Perform the following operations
Item Operation procedure
Set Multi You can set a number for making calls by
switching multi-numbers in this setting.
Number
1 z 1 to 3
2 z
Check setting
Select Yes
Number Set the phone number subscribed to Multi
Setting Number.
3 z
Select each item to set
Default
Basic
Name:
Number: Setting is available for each Additional
基本契約番号/
No1/Additional No2 (up to 20 one-byte
my phone or 10 two-byte characters). For Basic
number Number, the name set in Own Number
Additional No1: is displayed.
付加番号 1 /Not
Phone number:
recorded Set the subscribed phone number in
Additional No2:
Additional No1/Additional No2.
付加番号 2/Not
Multi number call:
recorded If set to Enable, you can make a call by
Multi number selecting the number to be shown to
call: Disable the receiver from the submenu.
Incoming calls Set the ring alert etc. for each additional
number.
melody setting
4 z 1 or 2
Default
z p
OFF to set
Individual setting:
Select whether to set the incoming call
setting individually.
Ring alert, Show image:
Setting procedure ☛P63
Making calls by selecting the number to notify
the other party
When making a call, you can select the number you
want to show to the other party.
･
When Multi number call is set to Disable in Number
Setting, multi-numbers cannot be selected.
z
Select Yes
z p
z
Select each item
Network Services 323
Next