NTT docomo FOMA D703i User Manual page 227

Press p
4
Saving without sending: m2
■
･
You can edit and send the unsent SMS.
☛P198
INFORMATION
Depending on signal conditions, the type of characters to
●
be sent or the other party's terminal, characters may not
be displayed correctly at the receiver side.
Even if Not notify is set in Caller ID Notification, the caller
●
ID is sent to the receiver when SMS is sent.
If you enter some symbols (
●
font type is English, the number of characters that can be
sent is reduced. In this case, you may not be able to
send the message even if the number of characters is
less than the limit. In this case, reduce the number of
characters and send it again.
When the memory is not enough, or the maximum
●
number of saved items is exceeded, SMS cannot be
composed. Delete unnecessary i-mode Mail and/or SMS
from Unsent messages. ☛P211
Even when SMS has been sent, a model incompatible
●
with SMS reception cannot receive SMS normally.
The font type and whether to receive the delivered report
●
must be set in SMS Setting beforehand. You can also
change the settings for the delivered report and storage
period while composing SMS.
When transmission is completed correctly, SMS is saved
●
in the Outbox folder of Outbox. However, when the sent
SMS matches the criteria specified in Sort Criteria, it is
saved in the specified folder. When the memory is not
enough, or the maximum number of saved items is
exceeded, the oldest sent mail is overwritten. Be sure to
protect sent mail you want to keep.
When transmission fails, an error message appears and
●
SMS is saved in the Unsent messages folder of Unsent
messages. You can edit and send the SMS from the
Unsent messages folder. ☛P198
When you set the delivered report to Request and send
●
SMS, you will receive a delivered report that notifies you
that the message has been received by the other party's
FOMA terminal. The delivered report is saved in Inbox.
｜＾{ } [ ] ~
and ￥) when the
When SMS is received
･
The maximum number of items that can be saved
☛P381
1 An SMS message is received
Receiving screen
Reception completed
Reception result screen
Press f while receiving SMS to stop
･
reception.
o or 1 z
2 Select a folder
SMS message
･
You can reply to (☛P201) or forward (☛P201)
the received SMS. The operation is the same
as for i-mode Mail.
INFORMATION
The reception result screen is displayed for about 15
●
seconds if you do not press any key, or until the ring alert
stops if ring time is set to 15 seconds or longer in Mail
Alert. To return to the previous screen immediately,
press c.
While receiving i-mode Mail or Message R/F, or
●
connecting to the Data Center, SMS is not automatically
received. Perform Check SMS.
Receive SMS
Flashing
When reception is
completed, the reception
result screen appears and
the mail ring alert sounds
and the keys light/flash.
: Unread SMS exists.
: Unread SMS and
i-mode Mail exist.
Reception result scrolls.
Number of received SMS
When reception fails, "×" is
indicated after Mail. To
receive unreceived
messages, perform Check
SMS.
z
Select an
Mail 225
Next