Description - NTT docomo FOMA D703i User Manual

INFORMATION
[Common]
You can also make a call in order of Step 2, Step 1. A call will be made automatically about 5 seconds after you have
●
pressed n (voice call) or t (videophone call) and entered the phone number.
If you hear a guidance requesting your caller ID when making a call, call again after setting FOMA terminal to send
●
caller ID. ☛P42
When you have subscribed to the Multi Number service, you can call after selecting a registered multi-number. ☛P323
●
[Videophone call]
If a videophone call is not connected, one of the following messages appears on the screen and then the standby
●
display returns. Note that the displayed message may not reflect the status of the other party's terminal correctly,
depending on the type of the terminal or the network service used by the other party.
Message
Busy.
Redial using voice call.
Upper limit exceeded. Connection
failed.
Connection failed.
Out of service area/power off.
Busy with packet transmission.
Set Caller ID to ON.
Check number, then redial.
Make call from i-mode web page.
*1 The message may also appear when the other party is in packet communication, depending on his/her terminal.
If a videophone call is not connected, redialing is automatically performed as described below:
●
Auto redial as
Call type
voice call
64K ON
OFF
32K ON
OFF
When there is an incoming call while dialing a videophone call or redialing, the dialing may be interrupted and the ring
●
alert may sound.
Even if sending/receiving the voice or image is aborted and
●
a videophone call, the call may be continued.
Please note that digital communication charges apply for videophone calls instead of voice call charges even if the
●
substitute image or Chara-den is used.
Videophone at 32K is intended for connection with devices such as PHS with which videophone calls at 64K may not be
●
available depending on the network condition. When a videophone call is made at 64K, the call type is automatically
switched to 32K when redialing if the communication environment of the other party is found to be the 32K area. When
ON is set for Auto redial as voice in Videophone Settings, redialing at 32K is also given priority. ☛P75
･
Even if a call is made at 32K, the 64K digital communication charges will apply.
46 Calls/Videophone Calls
The other party is busy.*
This message appears when the other party has activated Call Forwarding Service
with the forwarding destination set to a terminal incompatible with videophone.
This message appears when the upper limit of a billing plan with a charge limit
(such as Type Limit and Family Wide Limit) is exceeded.
Set Caller ID Notification to Notify and dial again.
･
The message may appear in cases other than the above.
The other party is outside the service area or the other party's terminal is turned off.
The other party is in packet communication.
This message appears in case of connecting without notifying the caller ID (when
accessing to V-Live or visualnet).
You dialed the phone number not used.
This message appears when using V-Live. Access to the IP site via i-mode then
make a videophone call on the site screen.
Redialing operation
64K → 32K → Voice call
64K → 32K → Disconnection
32K → Voice call
32K → Disconnection

Description

1
If redialing as voice call occurs, voice call charges apply.
(voice only) or (image only) appears during