NTT docomo FOMA D703i User Manual page 39

Table of Contents

Advertisement

If you use FOMA terminal for an extended period while charging the battery with the AC or DC adapter
connected, the battery may not be charged temporarily by temperature rise.
Insert or remove the connector to/from FOMA terminal slowly and firmly without forcing it. When
removing it, be sure to press the release buttons on both sides of the connector and pull it out. Forcibly
pulling the connector could cause equipment failure.
Insert or remove the connector straight to/from FOMA terminal.
Battery pack life
The battery pack is a consumable part and will gradually wear out. Each time it is charged, it will accept
slightly less charge than the previous time.
When the battery charge lasts only half as long as when it was new, replace it with a new one immediately,
as the end of battery pack life is approaching. Depending on usage, the battery pack may swell as it nears
the end of its life, but this will not cause a problem.
The battery pack life is about 1 year. However, if you repeat charging/discharging for a short time, charge in
high temperature environments or keep charging for a long period of time, the battery pack life may become
shorter.
FOMA terminal uses a lithium ion battery containing valuable materials that should be recycled. To protect
the environment, return used batteries to an NTT DoCoMo service counter, NTT DoCoMo agent or recycling
center.
Please take the following precautions when recycling batteries:
Attach a piece of adhesive tape on the terminals of used battery packs.
Do not disassemble or modify battery packs.
Charging from a wall outlet
Use the FOMA AC Adapter 01 (optional) to charge the battery. Also it can be used with the Desktop Holder D11
(optional).
The battery pack can only be charged when it is attached to FOMA terminal.
For details, refer to the manuals for the AC adapter and the Desktop Holder.
■ Charging the battery with the AC adapter alone
Charging
indicator
Release button
100 V AC
outlet
Power
plug
Connector
AC
(
up)
adapter
aUnfold the power plug from the AC
adapter and plug it into a 100 V AC
outlet.
bOpen the external connection terminal
cap of FOMA terminal.
cInsert the AC adapter connector in
firmly until it clicks.
dCheck that charging starts.
Check that the charging indicator lights in red.
When charging is completed, remove the
AC adapter connector from FOMA terminal
while pressing the release buttons on both
sides of the connector, and unplug the AC
adapter from the outlet. Then, close the
terminal cap.
Before Using D703i
Li-ion
37
Next

Advertisement

Table of Contents
loading

Table of Contents