Composing i-mode Mail/Deco-mail
Composing and sending i-mode Mail
a2
z
1
Select
Mail composition screen
2
Select Direct input
(up to 50 one-byte characters)
・
When sending mail to an i-mode terminal, you
may omit "@docomo.ne.jp" in the mail address.
In 5-touch Input Method, press 1 repeatedly
・
in the alphabet input mode to enter " . ", "@",
" - ", etc. In addition, ".com", ".ne.jp", ".co.jp",
etc. can be entered by pressing (
repeatedly in the alphabet input mode.
・
When the other party has registered a secret code,
enter the other party's i-mode terminal phone
number followed by the 4-digit secret code.
■
Selecting from the sent message log:
Select Sent messages
・
The address of mail receiver is set.
■
Selecting from the received message log:
Select Received messages
・
The address of mail sender is set.
■
Searching the phonebook: Select View
z
phonebook
Select a party
■
Using a mail group: Select Mail group
Select a mail group
・
If the total of entered addresses exceeds 5,
the mail group cannot be added.
Highlight a mail group and press m to
・
check the mail group details.
z
3
Select
field
to 30 one-byte or 15 two-byte characters)
Menu 12
Compose Message
field
The number of total
bytes of the characters
and decoration data in
the message (1 two-byte
character is 2 bytes)
z
Enter the address
z
Select a log
z
Select a log
z
Enter the subject (up
z
4
Select
Enter the message (up to
10,000 one-byte or 5,000 two-byte characters)
・
Line feeds can be inserted in the message.
Press # to enter a line feed in 5-touch Input
Method (except for the one-byte/two-byte
numeric modes).
・
A space of one- or two-byte or a line feed is
also counted as a character in the message.
・
If Deco-mail pictogram (pictogram D) is inserted
in the message, it will become Deco-mail.
Text can be decorated. ☛P190
・
Inserting a signature: m55
■
Press p
5
Pressing o on the connecting screen or
・
pressing p on the sending screen stops
sending and saves the i-mode Mail to the
Unsent messages folder of Unsent messages.
Even when saved in the Unsent messages folder,
the i-mode Mail may be sent depending on the
operation timing.
・
When you are outside the service area and the
auto-send mails already saved is 4 or less,
a confirmation screen appears asking whether
to send mail automatically in the service area.
When you select Yes, the mail is saved as auto-
send mail in the Unsent messages folder of
Unsent messages.
INFORMATION
When mail exceeding 10,000 bytes was automatically
●
saved due to start of other functions, part of the mail
being composed may not be saved.
Depending on signal conditions, characters may not be
●
displayed correctly at the receiver side.
When transmission is completed correctly, the i-mode
●
Mail is saved in the Outbox folder of Outbox. However,
when the sent mail matches the criteria specified in Sort
Criteria, it is saved in the specified folder. When the
memory is not enough, or the maximum number of saved
items is exceeded, the oldest sent mail is overwritten. Be
sure to protect sent mail you want to keep.
When transmission fails, an error message is displayed
●
and the i-mode Mail is saved in the Unsent messages
folder of Unsent messages. You can edit and send i-mode
Mail from Unsent messages.
Even if i-mode Mail is sent correctly, "Transmission
●
failed." may be displayed depending on signal conditions,
and the mail may be saved in the Unsent messages folder
of Unsent messages.
Mail
189
Next