NTT docomo FOMA D703i User Manual page 423

キャンセル
5 Click
screen appears
6
Enter the dialup connection (APN)
･
Enter in the format "AT + CGDCONT =<cid>,
"PPP", "APN"".
<cid> : Enter any number between 2, 4 to 10.
"PPP" : Enter "PPP".
"APN" : Enter the dialup connection (APN) in
quotation marks.
If OK is displayed, the dialup connection (APN)
has now been set.
■
Resetting dialup connection (APN) settings:
AT + CGDCONT =
Resets all cids.
･
The settings are restored to the default
settings for <cid> = 1 and 3, and the
settings for <cid> = 2, 4 to 10 are
cleared.
AT + CGDCONT=<cid>
Resets the specified cid.
■
Checking dialup connection (APN) settings:
AT + CGDCONT?
■ When nothing is displayed even if AT
command is entered: ATE1
･ For details ☛P27
Check that OK is displayed and click
7
ファイル ハイパーターミナルの終
and
了
(End HyperTerminal)
･
現在、接続されています。切断してもよ
After
ろしいですか？
(Connecting now. Disconnect?)
はい
appears, click
･ "XXX"
と名前付けされた接続を保存しますか
(Save the connection named "XXX"?) appears.
いいえ
Click .
when the connection
z
Press
.
Dialup connection (APN) and
registration number (cid)
The dialup connection (APN) for packet
communication can be set for registration numbers
between cid1 to 10 in FOMA terminal. By default,
"mopera.ne.jp" is set for cid1 and "mopera.net" for
cid3. For connecting to other providers or corporate
LANs, register the dialup connection (APN) for cid2, 4
to 10.
･
For the dialup connection (APN), inquire your
provider or network administrator.
･
The dialup connection settings can be considered
as phonebook registration for packet
communication. The comparison between dialup
connection settings and the FOMA terminal
phonebook entries is as follows:
Dialup connection
settings
Registration
number (cid)
APN
･
The registered cids become the connection
numbers of dialup connection setting.
Setting to show/hide caller ID
Take care when disclosing your caller ID since it is
important information.
･
Settings must be "show" for using mopera U /
mopera.
Default not set
Example For Windows XP
1 Perform Steps 1 to 5 of "Setting the dialup
connection (APN) for packet
communication" ☛P17
2 Set to show (186)/hide (184) caller ID
during packet communication
Enter in the format "AT ＊ DGPIR=<n>".
AT ＊ DGPIR = 1
When packet communication connection is
established, "184" is added to connect to the
?
dialup connection (APN).
AT ＊ DGPIR = 2
When packet communication connection is
established, "186" is added to connect to the
dialup connection (APN).
■ When nothing is displayed even if AT
command is entered: ATE1
･ For details ☛P27
18
FOMA terminal phonebook
entries
Registration number
(Phonebook No.)
Party's phone number
Next