NTT docomo FOMA D703i User Manual page 409

Connecting FOMA terminal to PC
The connection should be made with the PC and
FOMA terminal both switched on.
･
Be sure to install the communication configuration
file (driver) before connection. ☛P5
Connecting to PC
Connect by using the FOMA USB Cable (optional).
aOpen the cap on the FOMA terminal's
external connection terminal
bInsert one end of the FOMA USB Cable into
the FOMA terminal's external connection
terminal until it clicks
cInsert the other end of the FOMA USB Cable into
the PC USB connector
･
When a PC and FOMA terminal are connected,
appears on the screen of FOMA terminal.
does not appear before installing the
communication configuration file.
･
If you connect FOMA terminal to a PC before
installing the communication configuration file,
the detecting wizard screen of new hardware
will be displayed. In that case, remove FOMA
terminal and click
the wizard.
Release button
■ Removing FOMA USB Cable
Pull the connector for PC out from the side of PC.
Be sure to press release buttons on both sides of
the connector for FOMA terminal. Forcing to pull it
out may cause a malfunction.
キャンセル
(Cancel) to exit
USB connector
Connector
(label facing up)
Connecting while charging
FOMA terminal can be connected using a desktop
holder (optional) during the charging. However,
charging time becomes longer.
aConnect the desktop holder to the AC adapter
･
Plug the AC adapter into the wall outlet
bConnect FOMA terminal and FOMA USB Cable
cAlong with the desktop holder, insert FOMA
terminal at an angle as shown in the figure
･
Pull out the FOMA USB Cable in front of the
desktop holder when inserting FOMA terminal.
･
Check that the charging indicator lights in red.
Desktop holder
INFORMATION
● Do not remove the FOMA USB Cable during data
communication, or give shock to FOMA terminal and
desktop holder. It may cause the interruption of
charging or data communication, malfunction or
failure of PC or FOMA terminal, or loss of data.
● Starting to charge during data communication may
not complete charging. To complete charging, it is
recommended that you end the data communication
first, and then start charging.
4
AC adapter connector
( facing up)
Charging indicator
FOMA USB Cable connector
for FOMA terminal
(label facing up)