NTT docomo FOMA D703i User Manual page 159

･
Scratches, dirt, damages, the low print quality, the
strong reflection of light or some QR code versions
may prevent the codes from being scanned.
･
You can activate Bar Code Reader on the
character entry screen and enter the scanned
data directly. ☛P334
JAN Code
The JAN code is one of the bar codes indicating
numbers with the vertical lines (bars) of different
width. The bar codes of 8 digits (JAN8) or 13 digits
(JAN13) can be scanned.
The JAN code below shows the numeral data
"4942857127812".
QR Code
The QR code is one of the two-dimensional codes
indicating a string of alphanumeric and other
characters (kanji, kana and pictograms) or data such
as melody or image with the vertical and horizontal
patterns.
The left QR code shows the text
data "FOMA D703i".
Scanning the code
Keep the camera
about 7 to 10 cm
away from the code
to scan.
m61
z
1
Slide the macro mode
switch to (Macro)
Macro mode switch
(switched to Macro)
･
After bar code reading finished, turn the macro
mode switch back to
make the camera ready for a next shooting
occasion. If you shoot a distant object without
canceling (Macro), you cannot get a sharp
picture.
･
To read a large size code, switch the mode to
the normal mode.
Approx.
7 to 10 cm
(normal mode) to
･
During bar code reading, the following
operations are enabled:
d ：Switch to the same size
u ：Switch to the double size
To set flicker adjustment: m1
･
3
For details of settings ☛P155
･
･
This setting is also reflected to the flicker
adjustment setting for the videophone and
camera. ☛P73, P155
2
Scan the code
When you point the camera toward the code, the
code is scanned automatically. If scanned
correctly, a confirmation sound is played and the
scanned data is displayed.
･
When it is hard to read the code, adjust the
distance, angle or direction of the code and the
camera. This may enable the code to be read.
Switching to the same size may also work out.
･
If the code cannot be read within 30 seconds
after key operation, Could not scan. appears on
the screen. If the code still cannot be read within
another 30 seconds, Could not scan. appears
again and Bar Code Reader terminates.
･
If the data exceeds 11,000 one-byte or 5,500
two-byte characters, the exceeded characters
are not displayed, but can be saved.
･
When scanning is paused such as while a
submenu is displayed, the icon
the upper right of the screen changes to
Re-scanning the code: p
■
Press m4
3
The scanned data is saved.
･
When 5 data items have already been saved or
the memory is not enough, a confirmation
screen appears asking whether to delete the
saved data. Select Yes to delete the saved
data.
■
Copying the text data in the scanned data:
a m1 z
Select the start position to
copy
To copy the entire text data: mo
･
b Select the end position to copy
z 1 to
indicated at
.
Camera 157
Next