Charging The Battery Of Foma Terminal - NTT docomo FOMA D703i User Manual

Table of Contents

Advertisement

Charging the battery of FOMA terminal

When the battery level is low, charge the battery.
The battery level icon shows how much charge remains in the battery. ☛P39
Charging time and operation time on full charge (estimates)
Charging time
Approx.
During a voice call: Approx. 120 minutes
120 minutes
During a videophone call: Approx. 80 minutes
Continuous call time is an estimate of call time for FOMA terminal when it can send and receive
signals normally.
Continuous standby time is an estimate of operation time of FOMA terminal when it is able to receive
signals normally. The call time and standby time may be reduced to about half, depending on the
amount of charge in the battery, the function settings, the ambient temperature and signal conditions
(radio waves do not or hardly reach). Using i-mode communication reduces the call (communication)
time and standby time. Even if you do not make a call or use i-mode, the call (communication) time
and standby time will be reduced by composing i-mode Mail, or starting the i-
downloaded from sites or on the i-
Continuous standby time (while standing still) is the average operation time of FOMA terminal when it
is standing still and able to receive signals normally.
Continuous standby time (while moving) is the average operation time of FOMA terminal that is
standing still, moving and outside the service area when it is able to receive signals normally.
Alternatively, if you perform data communication or Multiaccess, use the camera, or play video/
i-motion or music, the call (communication) time and standby time will be reduced.
Starting/ending charging and other items to note
The battery pack can be charged regardless of whether FOMA terminal is turned on or off. However,
charging takes longer with the power turned on.
When charging starts, the charging indicator lights in red.
When FOMA terminal is turned on, the charge alert sounds and the battery level icon blinks.
Status
Charging
Charged
If the charging indicator does not light in red at the start of charging or it blinks in red, charging is unsuccessful.
The battery may not be charged when the temperature of FOMA terminal is high. Stop any function in progress
and confirm that the temperature is low before charging again. If the battery pack still cannot be charged even
after charging again, contact "Repairs" on the back of this manual.
When charging is completed with FOMA terminal turned on, the charge alert sounds and the battery
level icon lights.
Do not charge the battery for an extended period (longer than a full day) with FOMA terminal turned
on. FOMA terminal uses power after charging is completed until FOMA terminal is unplugged from the
adapter. In such a case, the AC or DC adapter charges again but when FOMA terminal is removed in
the middle of charging, the following could occur:
Low battery level
Message appears indicating that the battery runs down.
FOMA terminal is operational for a short time.
If the battery is fully charged, connecting FOMA terminal to the AC or DC adapter may not start
charging.
36
Before Using D703i
Continuous call time
ppli standby display.
α
Icon (
)
Charging indicator
Blinks
Lights in red
Lights
Goes off
Continuous standby time
While standing still: Approx. 400 hours
While moving: Approx. 290 hours
ppli software
α
Meaning
Charging normally.
Charging completed normally.

Advertisement

Table of Contents
loading

Table of Contents