Configuring Ad-Based Routing Rules - AudioCodes Mediant 3000 User Manual

User's Manual
16.3.11.2

Configuring AD-Based Routing Rules

The following procedure describes how to configure outbound IP routing based on LDAP
queries.

To configure LDAP-based IP routing for Lync Server:
1. Configure the LDAP server parameters, as described in 'Configuring LDAP Servers'
on page 223.
2. Configure the AD attribute names used in the LDAP query:
a. Open the Advanced Parameters page (Configuration tab > VoIP menu > SIP
Definitions > Advanced Parameters).
Figure 16-23: LDAP Parameters for Microsoft Lync Server 2010
b. Configure the LDAP attribute names as desired.
3. Gateway application: Configure AD-based Tel-to-IP routing rules:
a. Open the Outbound IP Routing table (Configuration tab > VoIP menu > GW and
IP to IP > Routing > Tel to IP Routing). For more information, see Configuring
Outbound IP Routing Table on page 427.
b. Configure query-result routing rules for each IP domain (private, PBX / IP PBX,
Lync clients, and mobile), using the LDAP keywords (case-sensitive) for the
prefix destination number:
♦
♦
♦
♦
♦
c. Configure a routing rule for routing the initial Tel call to the LDAP server, using
the value "LDAP" for denoting the IP address of the LDAP server.
d. For alternative routing, enable the alternative routing mechanism and configure
corresponding SIP reasons for alternative routing. For this feature, alternative
routing starts from the table row located under the LDAP query row.
Version 6.8
PRIVATE: Private number
OCS: Lync client number
PBX: PBX / IP PBX number
MOBILE: Mobile number
LDAP_ERR: LDAP query failure
241
16. Services
Mediant 3000