Configuring Sip User Part For Srs - AudioCodes Mediant 3000 User Manual

User's Manual
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 16-1: SIP Recording Routing Parameter Descriptions
Parameter
Index
[SIPRecRouting_Index]
Recorded IP Group ID
[SIPRecRouting_RecordedIPGro
upID]
Recorded Source Prefix
[SIPRecRouting_RecordedSourc
ePrefix]
Recorded Destination Prefix
[SIPRecRouting_RecordedDesti
nationPrefix]
Peer IP Group ID
[SIPRecRouting_PeerIPGroupID]
Peer Trunk Group ID
CLI: peer-trunk-group-id
[SIPRecRouting_PeerTrunkGroupI
D]
Caller
[SIPRecRouting_Caller]
Recording Server (SRS) IP Group
ID
CLI: srs-ip-group-id
[SIPRecRouting_SRSIPGroupID]

16.1.3 Configuring SIP User Part for SRS

You can configure the SIP user part of the Request-URI for the recording server (SRS).
The device inserts this user part in the SIP To header of the INVITE message sent to the
SRS.

To configure the SIP user part for SRS:
1. Open the SIP Recording page (Configuration tab > VoIP menu > Services > SIP
Recording).
2. In the 'Recording Server (SRS) Destination Username' field, enter a user part value
(string of up to 50 characters).
3. Click Submit, and then save ("burn") your settings to flash memory.
Version 6.8
Defines an index number for the new table record.
Defines the IP Group participating in the call and the recording
is done on the leg interfacing with this IP Group.
Note: For an SBC RTP-SRTP session, the recorded IP Group
must be set to the RTP leg if recording is required to be RTP, or
set to the SRTP leg if recording is required to be SRTP.
Defines calls to record based on source number or URI.
Defines calls to record based on destination number or URI.
Defines the peer IP Group that is participating in the call.
Defines the peer Trunk Group that is participating in the call
(applicable only to Gateway calls).
Defines which calls to record according to which party is the
caller.

[0] Both (default) = Caller can be peer or recorded side

[1] Recorded Party (in Gateway, IP-to-Tel call)

[2] Peer Party (in Gateway, Tel-to-IP call)
Defines the IP Group of the recording server (SRS).
Note: The SIP Interface used for communicating with the SRS
is according to the SRD assigned to the SRS IP Group (in the IP
Group table). If two SIP Interfaces are associated with the SRD
- one for "SBC" and one for "GW &IP2IP" – the device uses the
"SBC" SIP Interface. If no SBC SIP Interface type is configured,
the device uses the "GW & IP2IP" interface.
215
Description
16. Services
Mediant 3000