AudioCodes Mediant 3000 User Manual page 232

The following procedure describes how to configure the device's LDAP cache in the Web
interface. For a full description of the cache parameters, see 'LDAP Parameters' on page
962.

To configure the LDAP cache:
1. Open the LDAP Settings page (Configuration tab > VoIP menu > Services > LDAP
> LDAP Settings).
Figure 16-12: LDAP Settings Page - Cache Parameters
2. Under LDAP Cache, do the following:
a. From the 'LDAP Cache Service' drop-down list, select Enable to enable LDAP
cache.
b. In the 'LDAP Cache Entry Timeout' field, enter the duration (in minutes) for which
an entry in the LDAP cache is valid.
c. In the 'LDAP Cache Entry Removal Timeout' field, enter the duration (in hours)
after which the device removes the LDAP entry from the cache.
3. Click Submit, and then reset the device with a burn-to-flash for your settings to take
effect.
The LDAP Settings page also provides you with the following buttons:

LDAP Refresh Cache by Key: Refreshes a saved LDAP entry response in the cache
of a specified LDAP search key. If a request with the specified key exists in the cache,
the request is resent to the LDAP server.

LDAP Clear All Cache: Removes all LDAP entries in the cache.
User's Manual 232
Mediant 3000
Document #: LTRT-89738