Date And Time; Configuring Date And Time Manually - AudioCodes Mediant 3000 User Manual

User's Manual
12

Date and Time

The date and time of the device can be configured manually or it can be obtained
automatically from a Simple Network Time Protocol (SNTP) server.
12.1

Configuring Date and Time Manually

You can manually configure the date and time of the device (instead of using an NTP
server), as described in the procedure below. You can also configure the following with
your manually configured date and time:

UTC time offset (e.g., GMT +1). To configure the offset, use the 'NTP UTC Offset'
(NTPServerUTCOffset) parameter (see 'Configuring Automatic Date and Time using
SNTP' on page 122)

Daylight Saving Time (DST) - see 'Configuring Daylight Saving Time' on page

To manually configure the device's date and time, using the Web interface:
1. Open the Regional Settings page (Configuration tab > System menu > Regional
Settings).
2. Enter the current date and time of the geographical location in which the device is
installed.
3. Click Submit.
Notes:
•
If the device is configured to obtain the date and time from an SNTP server, the
fields on this page are read-only, displaying the received date and time.
•
After performing a hardware reset, the date and time are returned to their defaults
and thus, should be updated.
Version 6.8
Figure 12-1: Regional Settings Page
121
12. Date and Time
123
Mediant 3000