AudioCodes Mediant 3000 User Manual page 980

Function
STM-1/OC-3 Interface
T3 Interface
Gigabit Ethernet (GbE)
ESD Connectors
Alarm Terminal Block
Closures
BITS/SETS
AC Power
DC Power
Front Panel
Hardware Reset Button
RS-232
Fiber Optic Cable
PSTN (SDH) Single-Mode
Fiber
LAN (GbE) - Multi-Mode
Fiber
Power
AC Power Input
AC Power Supply
Voltages and Power
Consumption (Typical)
User's Manual
Two fiber optical 155.54-Mbps SFP modules (1+1 redundancy). The
SFP modules accept twin single-mode fiber optic cables terminated with
LC-type connectors (not supplied).
Note: Applicable only to Mediant 3000 with TP-6310.
Up to three SMB Tx/Rx connector pairs - receives RG-179/U coaxial
cables terminated with 75-ohm male SMB connectors (not supplied)
Note: Applicable only to Mediant 3000 with TP-6310.
Two (1+1 redundancy) Gigabit Ethernet ports, full-duplex mode with
auto-negotiation, available in one of the following (by customer ordered):

10/100/1000Base-TX RJ-45 connector interface (CAT 5 twisted pair)

10/100/1000Base-RX 1.25 Gbps optical SFP modules (hot
swappable)
ESD connectors
Connection mate (on PEM module) of type FK-MC 0.5/8-ST-2,5 Phoenix
Contact
RJ-48 connector (on the PEM module)
3-Prong IEC 60320 type AC power inlet on the PEM module.
Two available connection types (on PEM module):

2-pin terminal block screw connection type, suitable for up to 10
AWG field wiring applications connecting DC Power connector:
MSTB2.5/2-STF (5.08 mm) from Phoenix Contact. Cable connection
mate: PC4/2-STF-7,62 (AudioCodes supplied)

2-pin terminal block crimp connection type, supplied with 14-16 AWG
cable crimped to connector. [2 x crimp terminal female 10 AWG
(Phoenix P/N: STG-MTN 1,5-2,5) and 1x terminal block shroud FML
7.62mm 2 POLE CBL MNT (Phoenix female P/N: STG-MTN 1,5-2,5)]
Push button for resetting to default settings
3-pin connector on blade for RS-232 serial configuration (DB9 to 3-pin
cable adapter supplied)

Input Sensitivity: -32 dBm typical; -28 dBm maximum

Output Power: -15 dBm minimum; -8 dBm maximum
Note: Applicable only to Mediant 3000 with TP-6310.

Input Sensitivity: -29 dBm typical; -17 dBm maximum

Output Power: -9.5 dBm minimum; -2 dBm maximum
Note: For TP-8410, the optical LAN interface is supported only for a fully
populated TP-8410 or scalable configuration.
Power input range 100-240 VAC at a nominal 50/60 Hz line frequency.
Depends on installed blades and configuration:

TP-6310 OC-3/STM-1 Simplex:

2.1A @ 110VAC, 235W
980
Specification
Document #: LTRT-89738
Mediant 3000