Redirect Number And Calling Name (Display); Sdh / Sonet Configuration - AudioCodes Mediant 3000 User Manual

Gateway & enterprise sbc, family of media gateways & session border controllers

Hide thumbs Also See for Mediant 3000:

Table of Contents

User's Manual

the Sending Complete IE, you must configure the ISDNOutCallsBehavior parameter

to USER SENDING COMPLETE [2].

For more information on the above mentioned parameters, see PSTN Parameters on page

865. For configuring ISDN overlap dialing using the Web interface, see ''Configuring Trunk

Settings'' on page 361.

Redirect Number and Calling Name (Display)

The following tables define the device's redirect number and calling name (Display) support

for various ISDN variants according to NT (Network Termination) / TE (Termination

Equipment) interface direction:

NT/TE Interface

NT/TE Interface

* When using ETSI DivertingLegInformation2 in a Facility IE (not Redirecting Number IE).

The device supports STM-1 and OC-3 optical fiber transmission modes. Optical fiber

transmission is configured using the PSTNTransmissionType parameter (set to 1) and the

fiber mode is defined using the SdhFbrGrp_SdhSonetMode parameter (set to 1 for STM-1,

or 2 for OC-3). The device supports Automatic Protection Switch (APS) for these

STM-1 interface: provides short range Synchronous Digital Hierarchy (SDH) STM-1

interface compliant with ITU-T G.707 and ITU-T G.957. The interface operates at

155.52 Mbps over a single-mode fiber span. The device supports VC-4 payload at the

STM-1 signal level. The device supports the asynchronous VC-12 mapping (mapping

of E1s into VC12s and multiplexing of 63 VC12 into an STM-1 frame).

Relevant parameters:

PSTNTransmissionType - set to 'Optical SONET or SDH' (1).

For IP-to-Tel overlap dialing, to send ISDN Setup messages without including

Table 22-2: Calling Name (Display)

Table 22-3: Redirect Number

This section is applicable only to PSTN STM-1 / OC-3 ports on the TP-6310

22. Digital PSTN

Mediant 3000