AudioCodes Mediant 3000 User Manual page 174


To configure the IPSec Association table:
1. Open the IP Security Associations Table page (Configuration tab > VoIP menu >
Security > IPSec Association Table).
2. Click Add; the following dialog box appears:
Figure 14-12: IP Security Associations Table Page - Add Record Dialog Box
3. Configure the parameters, as required (for a description of these parameters, see the
table below). In the above figure, a single IPSec/IKE peer (10.3.2.73) is configured.
Pre-shared key authentication is selected with the pre-shared key set to 123456789.
In addition, a lifetime of 28800 seconds is set for IKE and a lifetime of 3600 seconds is
set for IPSec.
4. Click Submit.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 580.
Table 14-9: IP Security Associations Table Configuration Parameters
Parameter Name
Operational Mode
[IPsecSATable_IPsecMode]
Remote Endpoint Addr
[IPsecSATable_RemoteEndpointA
ddressOrName]
Authentication Method
[IPsecSATable_AuthenticationMet
hod]
User's Manual
Defines the IPSec mode of operation.

[0] Transport (default)

[1] Tunnel
Defines the IP address or DNS host name of the peer.
Note: This parameter is applicable only if the Operational
Mode is set to Transport.
Defines the method for peer authentication during IKE main
mode.

[0] Pre-shared Key (default)

[1] RSA Signature = in X.509 certificate
Note: For RSA-based authentication, both peers must be
provisioned with certificates signed by a common CA. For
more information on certificates, see Configuring Mutual TLS
174
Description
Document #: LTRT-89738
Mediant 3000