AudioCodes Mediant 3000 User Manual page 542

Parameter
Call Setup Rules Set Id
[IP2IPRouting_CallSetupRulesSetId]
Operation Routing Rule - Action
Destination Type
[IP2IPRouting_DestType]
User's Manual

[0] Any = (Default) This routing rule is used for all
scenarios (re-routes and non-re-routes).

[1] 3xx = Re-routes the request if it was triggered as a
result of a SIP 3xx response.

[2] REFER = Re-routes the INVITE if it was triggered as
a result of a REFER request.

[3] 3xx or REFER = Applies to options [1] and [2].

[4] Initial only = This routing rule is used for regular
requests that the device forwards to the destination. This
rule is not used for re-routing of requests triggered by the
receipt of REFER or 3xx.

[5] Broken Connection = If the device detects a broken
RTP connection during the call and the Broken RTP
Connection feature is enabled
(IpProfile_DisconnectOnBrokenConnection parameter is
configured to [2]), you can use this option as an explicit
matching characteristics to route the call to an alternative
destination. Therefore, for alternative routing upon broken
RTP detection, position the routing rule configured with
this option above the regular routing rule associated with
the call. Such a configuration setup ensures that the
device uses this alternative routing rule only when RTP
broken connection is detected.
Assigns a Call Setup Rule Set ID to the routing rule. The
device performs the Call Setup rules of this Set ID if the
incoming call matches the characteristics of this routing rule.
The device routes the call to the destination according to the
routing rule's configured action, only after it has performed
the Call Setup rules.
For configuring Call Setup rules, see ''Configuring Call Setup
Rules'' on page 251.
Determines the destination type to which the outgoing SIP
dialog is sent.

[0] IP Group = (Default) The SIP dialog is sent to the IP
Group's Proxy Set (SERVER-type IP Group) or
registered contact from the database (if USER-type IP
Group).

[1] Dest Address = The SIP dialog is sent to the address
configured in the following fields: 'Destination SRD ID',
'Destination Address', 'Destination Port', and 'Destination
Transport Type'.

[2] Request URI = The SIP dialog is sent to the address
indicated in the incoming Request-URI. If the fields
'Destination Port' and 'Destination Transport Type' are
configured, the incoming Request-URI parameters are
overridden and these fields take precedence.

[3] ENUM = An ENUM query is sent to include the
destination address. If the fields 'Destination Port' and
'Destination Transport Type' are configured, the incoming
Request-URI parameters are overridden and these fields
take precedence.

[4] Hunt Group = Used for call center survivability. For
542
Mediant 3000
Description
Document #: LTRT-89738